4:1 Mid-Length Headers with Adapters
1967-70 Mustang
351W Motor Swap
Part # THY-270-C

Application Specifics: Automatic Transmission Only

4:1 Mid-Length Headers with Adapters
1967-70 Mustang
351W Motor Swap

Application Specifics: Automatic Transmission Only

Header Style: 4:1 Mid-length Headers
Material: Steel
Finish: Silver Ceramic Coated
Weld Up: Yes, adapters must be welded to exhaust system
Primary Tube Diameter: 1-3/4"
Primary Tube Gauge: 14 Gauge
Collector Attachment: 3 Bolt Flange
Collector Diameter: 3"
Tuned: No
Flange Thickness: 3/8"
Bolts and/or Studs Included: Yes
Gaskets Included: Yes
Adapters/Reducers Included: Yes
Y-Pipe (Crossover) Included: No
Motor Mounts Included: No, contact us for recommendations
Quantity: Sold as a Pair
CARB E.O. #:THIS PART IS NOT C.A.R.B. APPROVED AND CANNOT BE SOLD OR SHIPPED TO ANY RESIDENT OR ADDRESSEE IN CALIFORNIA AND CANNOT BE INSTALLED ON ANY EMISSION CONTROLLED VEHICLE IN CALIFORNIA.
Warranty: Limited Lifetime to original purchaser

You just finished swapping that 351W Motor into your Mustang. Why choke it up by running the factory exhaust manifolds that leave much to be desired, and why drag a set of long tube headers on the ground every time the road gets a little bumpy? This killer set of headers is just a little shorter than true long tube headers. We designed these to give you the maximum in performance while keeping them short enough so they don’t smack the ground like long tube headers are known for. Of course the shorter design makes for a bit easier of an installation than long tubes so you definitely don't need to be lowered to run these. To make these headers last, we made them out of industry leading 14-gauge tubing with 3/8" thick flanges. Topping all of that off, all of our headers come beautifully ceramic coated to greatly reduce under-hood temperatures and protect them from the environment. All of this 100% American made, and backed by our lifetime warranty of course!